Alarm Window
There are two ways to view alarms, both of which display the alarm list with the point
system name and status:
● Alarm button. Provides direct access to the list of unacknowledged alarms.
● Alarm menu. Displays any point in alarm, regardless if it has been acknowledged
or not and provides three generic filters:
– Unacknowledged Alarms filter allows you to filter all alarms and lists only
unacknowledged alarms in local system.
– All Alarms filter allows you to view all acknowledged and unacknowledged
alarms in the system.
– Failures/Faults filter allows you to view all failures/faults in the system for which
alarming has been enabled.
Pressing the INFO button for point information displays:
● For APOGEE:
– system name
– alarm time
– acknowledged time
– acknowledge pending
– point value
– point status
● For each of the three APOGEE BACnet states (off-normal, normal, and fault):
alarm enable, alarm time, acknowledged time, point value, and point status.
Figure 7: INFO for Alarms
Press ESC to close alarm window without affecting the alarm.
To Next Page
Loading...
