QAA75... / QAA78… / AVS37…
53
Siemens Operator / Room / Auxiliary devices CE1U2358en_04
Building Technologies 2014-09-26
3.2.2 Programming
Settings that cannot be made directly with the help of operating elements are made
through programming. For this purpose, the individual settings are structured in the
form of menus and operating lines, thus creating practical groups of settings.
The following example shows how to set the time of day and the date.
NOTICE
When pressing the ESC button, you go one step back; adjusted values will
not be adopted
● If no setting is made for 8 minutes, the display returns automatically to the
basic display
● Operating lines may be hidden, depending on the type of controller, the
configuration made and the user level
Operation Display example Description
1 Basic display.
If the basic display is not shown, press the ESC
button to go back.
Press OK.
2
The bottom section of the display shows various
menus.
Turn the setting knob until operating page
Time
of day and date
appears.
Press the OK button to confirm.
Setting principle
Example "Setting the
time of day"
To Next Page
Loading...
Need help?
General
