Siemens RDF301 Basic Documentation

8 / 94
Siemens
RDF301, RDF301.50..., RDF600KN
Building Technologies
1.5
Target audience, prerequisites
This document assumes that users of the RDF
the ETS
and/or Synco ACS
It also presupposes that these users are aware of the specific conditions associ
ated with KNX.
In most countries, specific KNX know
certified by the
For
reference documentation, see section
1.6
Glossary
The inputs, outputs and parameters of an application can be influenced in various
ways. These are identified by the following symbols in this
Parameters identified by this symbol are set using
Parameters identified by th
Setting RDF KNX parameters is only supported by the following tool
versions:
– ETS3
or
– ACS v
ersion 5.11
Inputs and outputs identified by this symbol
They are called communication objects (CO).
The communication objects of the
partly in
LTE Mode
A list of the parameters is shown in section
ETS
ACS
STOP
Note!
RDF301, RDF301.50..., RDF600KN
, RDF600KN/S Basic D
ocumentation
Target audience, prerequisites
This document assumes that users of the RDF
KNX
thermostat
and/or Synco ACS
tools and able to use them.
It also presupposes that these users are aware of the specific conditions associ
ated with KNX.
In most countries, specific KNX know
-how is conveyed
through training centers
certified by the
KNX Association (see www.knx.org/).
reference documentation, see section
1.2.
Glossary
The inputs, outputs and parameters of an application can be influenced in various
ways. These are identified by the following symbols in this
document
Parameters identified by this symbol are set using
ETS.
Parameters identified by th
is symbol are set using
the ACS tool.
Setting RDF KNX parameters is only supported by the following tool
or
higher
ersion 5.11
or higher
Inputs and outputs identified by this symbol
communicate with other KNX devices.
They are called communication objects (CO).
The communication objects of the
RDF KNX
thermostats work
LTE Mode
, and partly
in both. These objects are described accordingly.
A list of the parameters is shown in section
3.13.
ocumentation
CE1P3171en
2017-12-07
thermostat
s are familiar with
It also presupposes that these users are aware of the specific conditions associ
-
through training centers
The inputs, outputs and parameters of an application can be influenced in various
document
:
the ACS tool.
Setting RDF KNX parameters is only supported by the following tool
communicate with other KNX devices.
thermostats work
partly in S-Mode,
in both. These objects are described accordingly.

Siemens RDF301 Specifications

General

Brand	Siemens
Model	RDF301
Category	Thermostat
Language	English