Siemens RDF301

88 / 94
Siemens
RDF301, RDF301.50..., RDF600KN
Building Technologies
7.
Mechanical design
7.1
General
The thermostats consist of 2 parts:
∂
Front panel with
sensor
.
∂
Mounting base with power electronics
The rear of the mounting base
Slide the front panel in the mounting base and snap on.
RDF301, RDF600KN
1 Operating mode selector
2
Button for
3 Buttons
to
RDF301.50,
RDF600KN/S
4 Four buttons to control KNX actuators via KNX
(functions: switching, dimming, blind control, 8
RDF301.50H 5 Four
dedicated
via KNX
S
For o
peration
1
3
RDF301, RDF301.50..., RDF600KN
, RDF600KN/S Basic D
ocumentation
Mechanical design
General
The thermostats consist of 2 parts:
Front panel with
electronics, operating elements and built
.
Mounting base with power electronics
.
The rear of the mounting base
carries
the screw terminals.
Slide the front panel in the mounting base and snap on.
RDF301.50, RDF600KN/S
RDF301.50H
1 Operating mode selector
Button for
fan operation
to
adjust setpoints and control parameters
4 Four buttons to control KNX actuators via KNX
S-Mode
(functions: switching, dimming, blind control, 8
-bit scene)
dedicated
buttons for hotel functions (Make Up Room, Do Not Disturb)
S
-Mode (functions: switching)
peration
, refer to section 4.3.
2
2
1
3
4
4
5
1
ocumentation
CE1P3171en
2017-12-07
electronics, operating elements and built
-in room temperature
the screw terminals.
RDF301.50H
buttons for hotel functions (Make Up Room, Do Not Disturb)
5
2
3