Siemens RDH10RF User Manual

1
2 3
4 5 6
Press and release LEARN button
on the back of the transmitter
To test transmission press TEST on the
transmitter
This will switch relay on in receiver irrespective
of temperature
RF TEST appears in transmitter display. To switch
test off press TEST again
Configuration Instructions for the Siemens RF
units
Press and release SET button, this
puts the receiver into learn mode
Good signal is indicated by the LED
flashing green, then solid
No signal is indicated by the LED
flashing red, then solid
Orange LED indicates relay is on Pressing the RESET button for about 4
seconds will erase all ID codes in the
receiver. The set up procedure has to
be repeated to regain communication
Note: The transmitter and receiver are supplied in a single box already configured. This
procedure only needs to be followed in case of communication issues
PKGPT01027A

Siemens RDH10RF Specifications

General

Mounting	Wall-mounted
Wireless	Yes
Display	LCD
Frost Protection	Yes
Power Supply	Battery
Set Temperature Range	5°C to 30°C
Switching Voltage	230V AC
Wireless Range	30m