Chapter 3
Device Management
RUGGEDCOM RSG907R
Installation Guide
24 Configuring the Device
Terminal ID VT100
Ethernet Ports
Connect any of the available Ethernet ports on the device to a management switch and access the RUGGEDCOM
ROS console and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM
RSG907R is https://192.168.0.1.
For more information about available ports, refer to Chapter4, Communication Ports.
Section3.2
Configuring the Device
Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROS interface. For more information about configuring the device, refer to the
RUGGEDCOM ROS User Guide associated with the installed software release.
To Next Page
Loading...
Need help?
General