Siemens RUGGEDCOM RX1501 Installation Guide

RUGGEDCOM RX1501
Installation Guide
Chapter 2
Installing the Device
Connecting High AC/DC Power 13
4
5
6
4 1
5
1 6
2
3
Figure7:AC Terminal Block Wiring – Screw Terminal Block for HI Power Supplies
1.Not Connected 2.Removable Screw Terminal Block 3.Non-removable Screw Terminal Block 4.Positive/Live (+/L) Terminal
5.Ground Terminal 6.Negative/Neutral (-/N) Terminal
2. Connect the positive wire from the power source to the positive/live (+/L) terminal on the terminal block.
3. Connect the negative wire from the power source to the neutral/negative (-/N) terminal on the terminal block.
4. For screw terminal blocks, install the safety cover.

Siemens RUGGEDCOM RX1501 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RX1501
Category	Switch
Language	English