Siemens RUGGEDCOM RX1501 Installation Guide

RUGGEDCOM RX1501
Installation Guide
Chapter 3
Device Management
Accessing the CompactFlash Card 23
Section3.3
Accessing the CompactFlash Card
The RUGGEDCOM RX1501 features a removable CompactFlash (CF) card that stores configuration files, firmware
(active and backup versions), file-based feature keys and other system files.
CAUTION!
Configuration hazard – risk of data corruption/loss. Do not remove or insert the CF card when the
device is powered on.
The CF card should only be removed in the following scenarios:
• The chassis is defective (with the exception of power and media modules)
• The CF card is deemed defective or corrupt
• The device is rendered non-functional due to a serious configuration error, data corruption, or hardware fault
CAUTION!
Configuration hazard – risk of data corruption/loss. The following will void the warranty and
potentially result in configuration data corruption/loss:
• Using a CF card not approved by Siemens for use with this device
• Removing the CF card in any scenario other than those described in this section
Inserting the CF card
To insert the CF card into the device, do the following:
IMPORTANT!
The device should only be powered on when the CF card is present.
1. Make sure the device is powered down.
2. Remove the CF card access panel.
3. Insert the CF card into the slot until it is fully seated.

Siemens RUGGEDCOM RX1501 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RX1501
Category	Switch
Language	English