Siemens RVA63.242 - Page 15

15/218
Siemens Building Technologies Basic Documentation RVA63.242, RVA53.242 CE1P2373E
Landis & Staefa Division Handling 26.03.2001
• Check to ensure the fixing levers are
turned inward
• Check to make certain there is
sufficient space between the front
panel and the fixing levers
2373Z06
• Slide the controller into the panel cut-
out without applying any force
è Note:
Do not use any tools when inserting
the unit into the cut-out. If it does not
fit, check the size of the cut-out and
the position of the fixing levers.
2373Z07
Tighten the 2 screws on the front of the
controller
è Note:
Tighten the screws only slightly,
applying a torque of maximum
20 Ncm.
When tightening the screws, the
fixing levers automatically assume
their correct positions.
2373Z08
2. Check
3. Fitting
4. Fixing