201/218
Siemens Building Technologies Basic Documentation RVA63.242, RVA53.242 CE1P2373E
Landis & Staefa Division Application examples 26.03.2001
7 Application examples
This chapter contains all types of plant that can be handled by the controller. These
plant types use reference numbers some of which are not in a consecutive order. The
missing plant types can be covered by other controllers from the ALBATROS range.
• The plant type no. is identical with the number displayed on setting line 53
• The buffer storage tank application has no impact on the type of plant
• The following settings have no impact on the type of plant:
Setting line 95 (K6): settings 5 through 8 and 11
Setting line 96 (K7): settings 2 through 5 and 7
7.1 Structure of plant diagrams
The following summary of plant diagrams is structured in the form of a matrix. Since
application of the available functionality is very comprehensive, a complete
presentation of the diagrams would be somewhat confusing.
However, the selected structure demands observance of the following procedure to find
the required type of plant.
Basically, the presentations are subdivided into heat sources and plants. So, first of all,
select the type of heat source from the chapter with the same name.
No. C1 for a 2-stage burner without maintained boiler return temperature.
Based on the selected heat source variant, a choice of plant types is now available in
each group of plants.
Hence, in the above example, all plant types would be possible where there is a 1 in
column C of the relevant table.
The graphic presentations of the plant types always correspond to the possible full use
of the grouping given.
Introduction
Notes
Introduction
Select the heat source
To Next Page
Loading...
