Siemens RWF50.3 - 6.6 Starting the self-setting function

37/64
Building Technologies Division User Manual RWF50... CC1U7866en
Infrastructure & Cities Sector 6 Operation 25.07.2014
6.6 Starting the self-setting function
*
Press + for 5 seconds
*
Cancel with +
7866z04/0911
Figure 19: Display of self-setting function
When tUnE stops flashing, the self-setting function has been ended.
The parameters calculated by the controller are automatically adopted!

Note!
It is not possible to start tUnE in manual control or low-fire operation.
Start
Cancel