Siemens S120_EN_rev06-08062017.docx 10-3
10.3 PARAMETERS LIST
Below are listed the parameters of the list "User S120 Low" and their default values:
After the modify of the parameters of interest, it is always necessary to save the new values on
the hard memory of the Control Unit (Copy from RAM to ROM), in order to prevent a loss of data at the
first shut down (voluntary or accidental). Using STARTER software, you have to switch ONLINE, then
press the push button Copy from RAM to ROM . Alternatively, see the procedure described to the
chapter 9 for the setup by BOP
Table 21 - List of parameters
SETTING UPWARDS DIRECTION - CONFIGURAZIONE SALITA
Inspection Speed UP (2.2.9)
Releveling speed UP (2.2.8)
SETTING DOWNWARDS DIRECTION - CONFIGURAZIONE DISCESA
PreStart Speed value 2 (2.3.2.2)
PreStart Time value 2 (2.3.3.2)
PreStart Delay Additional value 2 (2.3.3D.2)
Final Dec Time value 2 (2.3.14.2)
Inspection Speed DOWN (2.3.9)
Releveling speed DOWN (2.3.8)
Plus Speed while EDV closing
RUPTURE VALVE TEST- TEST VALVOLA PARACADUTE
Parachute function (2.13.1)
Ramp-up time (ms) (2.13.3)
Ramp-down time (ms) (2.13.5)
Parachute Max.Speed TimeOut (2.13.4)
Emergency Speed Up (2.6.1)
Emergency Speed Down (2.6.2)
SHORT FLOOR - PIANO CORTO
Short Floor Speed Up (2.14.2)
Short Floor Speed Down (2.14.3)