Installation and removal
4.8 Mounting on a pedestal
SCALANCE S615
Operating Instructions, 10/2022, C79000-G8976-C389-07
43
4. Fit the connectors for the digital input and digital output, refer to the section "Digital
input/output (Page 53)".
5. Connect the device to the local network, refer to the section "Ethernet port (Page 55)".
6. Connect the terminal with as short a cable as possible ≤ 150 mm and a large cross-sectional
area ≥ 1.5 mm² to the functional ground of the system, see section "Grounding (Page 52)“
and section “Terminals (Page 25)“.
Dismantling
1. Disconnect all connected cables.
2. Using a screwdriver, pull down the catch on the rear of the device.
3. Remove the device from the pedestal.
To Next Page
Loading...
