Description of the device
3.6 Reset button
SCALANCE W774-1 /W734-1
Operating Instructions, 01/2017, C79000-G8976-C325-08
25
Functions of the reset button
The reset button has the following functions:
●
To restart the device, press the Reset button briefly.
Note
If you make changes to the configuration and restart immediately afterwards with the
reset button, the changes may be lost. If you restart the device using the WBM (menu
command "System > Restart") or using the CLI (command "restart" in the Privileged
EXEC Modus), the configuration changes are always retained.
If the "Load & Save" menu command of Web Based Management is unsuccessful, the
reset button can be used to load new firmware. This situation can occur if there is a
power outage during the normal firmware update. You will find further information in the
configuration manual in Downloading new firmware using TFTP without WBM and CLI.
●
Resetting the device to the factory defaults
The device can be reset to the factory defaults during operation. You will find more
detailed information in the configuration manual in Resetting the device to factory
defaults.
If you reset, all the changes you have made will be overwritten by factory defaults.
An inadvertent reset can cause disturbances and failures in the configured network with
further consequences.
To Next Page
Loading...
Need help?
General
