Preface
SCALANCE X-300
Operating Instructions, 05/2016, A5E01113043-20
5
For help on configuration and diagnostics using Web-based management, the CLI command
line interface, or SNMP, refer to the following documentation:
● Configuration Manual SCALANCE X-300 SCALANCE X-400
This configuration manual is available on the following media:
– On the supplied CD
– In 5 languages on the Internet on the pages of Siemens Automation Customer
Support under the following entry ID:
19625108 (http://support.automation.siemens.com/WW/view/en/19625108
)
● SIMATIC NET - Industrial Ethernet Network manual
This manual is available on the following media:
– On paper under order numbers:
- English version: 6GK1 970-1BA10-0AA1
- German version: 6GK1 970-1BA10-0AA0
– In German and English on the Internet on the pages of Siemens Automation Customer
Support under the following entry ID:
27069465 (http://support.automation.siemens.com/WW/view/en/27069465
)
If you have questions on the use of SIMATIC NET products, please contact your Siemens
sales partner.
The devices of the SCALANCE X-300 product line meet the requirements for the CE mark.
For more detailed information, refer to section Approvals, certificates, standards (Page 223).
Integration in STEP 7 projects
The current GSDML file must be used for integration in STEP 7 V5.4 SP5 projects. This
applies to all products covered by these operating instructions.
You can obtain the relevant GSD file from the Internet at:
46183514 (http://support.automation.siemens.com/WW/view/en/46183514
)
You will find the file for the firmware update V3.3.1 for X-300 under entry ID "46183538".
Explanations of many of the specialist terms used in this documentation can be found in the
SIMATIC NET glossary.
To Next Page
Loading...
Need help?
General