Siemens SIDOOR ATD430W - Parameter Assignment Using Additional Devices

Menu selection key – increases a parameter value
Menu selection key – decreases a parameter value
Parameters can be changed in both of the following menus:
• "MAIN MENU > Quick setup > Parameter setting"
• "MAIN MENU > General setup > Pro󹪝le parameters"
The desired parameter is selected with the menu selection keys and , and activated for the
setting with the Enter key (parameter value 󹪞ashes).
The parameter value can then be increased or decreased by pressing the corresponding key (see
above). The value is accepted by pressing the Enter key again.
Menu navigation
You can 󹪝nd the menu navigation of the SIDOOR SERVICE TOOL in the section (Page 271).
Digital display "H1"
You can see the operating states on the "H1" display. You can 󹪝nd the meaning of the digital
display in the section Operating state display (Page 303).
5.9.3 Parameter assignment using additional devices
Description
In addition to the parameter assignment options integrated in the controller, you can also assign
parameters via additional units. The following additional units are available for parameter
assignment:
• SIDOOR USER SOFTWARE
The SIDOOR USER SOFTWARE is part of the SIDOOR SOFTWARE KIT. You can 󹪝nd a detailed
description of the SIDOOR SOFTWARE KIT in the SIDOOR SOFTWARE KIT Operating
Instructions (
http://support.automation.siemens.com/WW/view/en/92711247).
• SIDOOR SERVICE TOOL
A detailed description of the SIDOOR SERVICE TOOL is available in the section SIDOOR
SERVICE TOOL (Page 271).
• SIDOOR SUPPORT app
You can 󹪝nd a detailed description of the SIDOOR SUPPORT app in the section SIDOOR LINK
and SIDOOR SUPPORT App (Page 280).
Controllers
5.9 Operation and con󹪝guration of the control unit
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA 181