Siemens SIDOOR ATD430W - Page 334

The default values and the set values are automatically set to the upper limit if the upper limit
is exceeded. It is therefore possible that the actual default values di󹪜er from the default values
in the table below.
Table A-46 Parameters and setting ranges for SIDOOR MDG3 L / R
Parameter Parameter ID Unit Pro󹪝le 1* Adjustment range
ATD4xxW
Slow end distance open p3660 mm 30 0 … 100
Slow start distance open p3661 mm 30 0 … 100
Slow start distance close p3662 mm 20 0 … 100
Slow end distance close p3663 mm 40 0 … 100
Maximum speed open p3664 mm/s 650 30 … 650*k1
Slow end speed open p3665 mm/s 40 30 … 90
Slow start speed open p3666 mm/s 60 30 … 90
Slow initial speed open p3667 mm/s 90 30 … 90
Maximum speed CLOSE p3668 mm/s 281 30 … 650*k1
Slow start speed close p3669 mm/s 60 30 … 90
Slow end speed close p3670 mm/s 40 30 … 90
Slow initial speed close p3671 mm/s 90 30 … 90
NDG speed (reduced) p3672 mm/s 281 30 … 650*k1
Acceleration ramp open p3673 mm/s
2
1300 250 … 1400*k1
Deceleration ramp open p3674 mm/s
2
600 150 … k2
Reversal ramp open/close p3675 mm/s
2
1200 150 … k2
Acceleration ramp close p3676 mm/s
2
500 250 … 1400*k1
Deceleration ramp CLOSE p3677 mm/s
2
500 150 … k2
Reversal ramp close/open p3678 mm/s
2
850 150 … k2
Idle torque open p3679 mA 1000 0 … 2500
Idle torque close p3680 mA 1000 0 … 2500
Peak torque close p3681 mA 3000 0 … 5000
Static force limit open p3682 N 75 70 … 300/k1
Static force limit close p3683 N 75 70 … 300/k1
Limit force end close p3684 N 75 70 … 300/k1
Static NDG-force (reduced) p3685 N 75 70 … 300/k1
Limit energy close p1202 J 4 0 … 100
Limit energy open p1203 J 4 0 … 100
Limit energy NDG p1204 J 4 0 … 100
* Default pro󹪝le (this pro󹪝le is automatically loaded at the 󹪝rst commissioning)
Appendices
A.2 Pro󹪝les and adjustment ranges
ATD4xxW for industrial applications
332 System Manual, 06/2022, A5E51901827B AA