Installation
2-13
SIMATIC 505–2556 Installation and Operation Guide
If
the line is blank or erroneous, re–check the module to ensure that it is
firmly seated in the slots. Generate the PLC I/O configuration chart again.
If the line is still incorrect, contact your Siemens Energy & Automation,
Inc., distributor or sales office.
NOTE:
In Advanced Operating Mode the module logs in to the PLC as 16X,
16Y
, 32WX, and 32WY
.
NOTE:
Refer to Hewlett–Packard Applications Note 290 or Omega
T
emperature Handbook, V
olume 26, Section T
, for ”practical thermocouple
measurement” applications.
NOTE:
For proper operation, ensure that the SIMA
TIC 505–2556 and the
thermocouple wires are not subjected to large temperature gradients during
operation.
To Next Page
Loading...
