Why Siemens I/O Systems showing incorrect values?
If your Siemens I/O Systems are displaying incorrect values, consider these potential causes: 1. Incorrect terminal block connections: Trace the wiring connections to ensure they are correct. 2. Noise on the signal wire exceeding the immunity level: Use shielded wire near power wires and check the ground wire to the base. 3. Incorrect or missing configuration: Correctly configure the I/O.
What to do if no functions are working on my Siemens Control Unit?
If no functions are working on your Siemens Control Unit, here's what you can check: * First, verify that you are logged in correctly. * If the login is correct, debug the ladder program, as it might not have executed. * Also, check if the offsets are incorrect and calculate the offsets starting address. * Finally, ensure that the functions are enabled in the ladder program after loading the data. Edit the ladder program to enable the function.
General| Brand | Siemens |
|---|---|
| Model | SIMATIC 505 |
| Category | Controller |
| Language | English |
To Next Page
