Siemens SIMATIC 505 - Powering Up;Restart the Controller; Power up Restart

128 •
••
• 6 - Programming Simatic 505 SoftShop
•
Disable Password-
Allows you to disable password
protection for the controller. If you have not already entered a
password for the controller, 505 SoftShop prompts you for
the current password. If the password you provide is not
correct, 505 SoftShop does not disable the password
protection. This function does not work unless you provide a
password.
Figure 6.13
Powering Up/Restart the Controller
Power Up Restart
Use
Power Up Restart
to clear all unforced X, Y and non-retentive C
elements on power up or restart of the controller. Retentive control
relays are not cleared. The WX and WY elements are not affected.