Siemens SIMATIC 505 User Manual

Simatic 505 SoftShop 2 - Installation •
••
• 5
2 - Installation
Installing 505 SoftShop
Before you begin installation, you should review the System
Requirements section in the Introduction chapter.
To install 505 SoftShop, turn your computer on and start Windows.
Usually, Windows can be started by typing "win" at the C:\> prompt.
The Windows Program Manager appears on the screen. Follow these
steps to install the software:
1. Insert the 505 SoftShop Disk in your computer’s CD-ROM
drive.
2. The CD should autostart, if not click the Windows Start
button. Then Click Run, and type x:\setup.exe, where x is the
letter for the CD-ROM drive.
3. Follow the instructions that appear on the screen.
4. After clicking Next, a 505 SoftShop Access Level Read/Load
Only Install box appears. From the install window entitled 505
SoftShop Access Level, you can decide if you want Full-
function, Read-only, or Load-only install (Figure 2.0).

Siemens SIMATIC 505 Specifications

General

Brand	Siemens
Model	SIMATIC 505
Category	Controller
Language	English