Siemens SIMATIC 505 - Appendix C Jumper Settings Log Sheet

Jumper Settings Log Sheet
C-1
SIMATIC 505–2556 Installation and Operation Guide
Appendix C
Jumper Settings Log Sheet
Record the configuration jumper settings on this log for future reference.
Make additional copies if necessary .
Figur e C-1 Factory Configuration Jumper Settings
NOTE: The SIMA TIC 505–2556 Thermocouple Input Module is calibrated at
the factory . No further calibration is required. All calibration parameters
are stored in non–volatile memory . There are no user adjustments on this
product. As shipped there is no jumper required on the CAL input.