BusAdapter BA 2xFC
5.2 Connecting
BusAdapter
22 Equipment Manual, 08/2020, A5E41449003-AB
Pin assignment
The following table shows the signal name and description of the pin assignment of the
BusAdapter BA 2×FC:
Table 5- 1 PROFINET IO pin assignment with BusAdapter BA 2×FC
Procedure
Watch the video sequence "Connecting the BusAdapter BA 2xFC to the interface module"
(https://support.industry.siemens.com/cs/ww/de/view/95886218)
To connect PROFINET IO to the PROFINET device via the BusAdapter BA 2xFC, follow these
steps:
1. Strip insulation from the sheath of the PROFINET connecting cable as follows:
Figure 5-2 PROFINET connecting cable
2. Pull back the locking slide and fold up the cover of the connection element.
3. Pull up the wire guide as far as it will go.
4. Insert the unstripped single cores of the PROFINET connecting cable into the cable routing as
far as it will go. Firmly press down the wire guide as far as it will go. Please refer to the color
coding.
To Next Page
Loading...
Need help?
General
