Siemens SIMATIC ET 200SP Product Information

Module overview of ET 200SP
1.2 CPUs
Product information on the documentation of the ET 200SP distributed I/O system
16 Product Information, 02/2021, A5E03799595-BG
Note
The CM AS
-i Master ST and F-CM AS-i Safety ST communication modules are supported as of
firmware V1.8 of the CPUs. Note the following additional requirements:
CM AS
-i Master ST:
•
Firmware version of the CM AS-i Master ST: V1.1
•
STEP 7 (TIA Portal): V13 SP1 Update 4 or higher
F
-CM AS-i Safety ST
•
Firmware version of the CM AS-i Safety ST: V1.0
•
STEP 7 (TIA Portal): as of V13 SP1 Update 4 and HSP0070 V3.0

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C