FM 351 First Steps in Commissioning
Getting Started, 07/2007, A5E01092707-01
5
Purpose of the Getting Started
1
Introduction
This Getting Started is intended to lead you through the five steps in commissioning a fully
functional application. Based on a practical example, it shows you how to execute a motion
via channel 1, and introduces the basic functions of FM 351 hardware and software, and
application-specific parameters. The references to the manual should give you an initial
overview of the information it contains.
It will take between 1 and 2 hours to work through the example, depending on your
experience.
To Next Page
Loading...
