Siemens simatic hmi op7 User Manual

B-10
Equipment Manual OP7, OP17
Release 04/99
Remedy:CauseMes-
sage
534 Information message: disk is full.
535 Disk access error .
536 Disk transfer error . Check the physical connection.
537 Information message: disk is blank.
538 Simultaneous accessing of data record by job and
operator.
Repeat uncompleted accessing ope -
ration.
539 The data records in the RAM for recipe no. x con -
tained errors and have been deleted.
If data records are stored in the Flash
memory they will remain valid.
540 The maximum number of data records has al -
ready been created.
541 ...
550
Specified variable not available on PLC Change configuration and retransfer .
551 An MPI/PPI connection to the PLC cannot be
established using the specified station address.
Check MPI station addresses and wi -
ring.
570 V ariable contains errors: variable name from Pro -
T
ool is used as parameter .
Check configuration. Frequently oc -
curs with NC variables and when
multiplexing.
571 S7 system diagnosis/ALARM_S returns error if
OP logs on/of f.
CPU operating system out of date.
600 Configuration error: overflow warning at basic
setting 1
601 Configuration error: message logging at basic
setting 1
602 Configuration of remaining buf fer space incor -
rect.
Correct the remaining buf fer space
and retransfer configuration.
604 Message does not exist. Configure message.
605 Process link is only configured symbolically .
Change configuration and retransfer .
606 T oo many message variables configured.
gg
607 Data type configured does not exist.
608 The process screen number does not exist.
Change configuration and retransfer .
609 Special object or operator object for message text
does not exist or is not permissible.
gg
610 Operator object for header or footer does not exist
or is not permissible.
If the fault is not corrected by perfor -
ming a restart, please contact the SI -
MA TIC H li
611 Special operator object for buf fer printout does
not exist or is not permissible.
g,p
MA TIC Hotline.
613 Data block not available or too short. Create data block of required length
on the PLC.
614 No entry present for log (header and footer not
present).
Configure log fully .

Siemens simatic hmi op7 Specifications

General

Brand	Siemens
Model	simatic hmi op7
Category	Control Panel
Language	English