8-5
Equipment
Manual OP7, OP17
Release 04/99
As
long as you have not confirmed an input value, you can terminate editing
with
ESC
. The old value is then displayed again.
T
o save a changed data record as a new data record, do not overwrite the
called data record when exiting the input screen. Instead, enter a new data
record number and, if necessary
, a new data record name before saving the
data record.
Proceed as follows:
Step Procedure
1
Position cursor in the field for the data record number
.
Enter the number
, and confirm.
2
Position cursor in the field for the data record name.
Enter the name, and confirm.
The data record name may not exceed 12 characters.
The next time you call the data record directory
, you will find the new data
record listed under the new data record number
.
Storing a changed
data record as a
new data record
To Next Page
Loading...
Need help?
General
