Siemens SIMATIC HMI series Getting Started

Migration Guide Comfort Panels
Getting Started, 03/2011, A5E03478626-01
43
Commissioning the HMI device
4
4.1 Overview
To transfer the migrated project from the configuration PC to the Comfort HMI device,
connect the Comfort HMI device with one of the following interfaces on the configuration PC:
● Ethernet
● USB
● PROFIBUS/MPI
After successful transfer, you can insert the system memory card in the Comfort HMI device
and activate automatic backup as part of the service concept.
In the event of a fault, it is usually sufficient to restart the device or update the operating
system. Resetting to factory settings ("bootstrapping") is only necessary in case of serious
errors, for example, in case of a corrupt file system.
4.2 Transferring a project
NOTICE
Note the information regarding connection of an HMI device to a configuration PC in the
operating instructions of the Comfort HMI device.
The project transfer is shown based on a USB connection.
Requirements
A project with configured Comfort HMI device is open in WinCC.

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB