Siemens SIMATIC HMI series Getting Started

Data transfer from STEP 7
5.2 Scenario 1: "Update to WinCC V11"
Migration Guide Comfort Panels
50 Getting Started, 03/2011, A5E03478626-01
Result
The STEP 7 tags are available in the WinCC project and can be used.
Note
Limitation
If you change the tags in STEP 7, you must make these changes manually in the HMI
project.
Otherwise: Absolute addresses are retained. Changes in STEP 7 are not synchronized
automatically.

Siemens SIMATIC HMI series Specifications

General

Brand	Siemens
Model	SIMATIC HMI series
Category	Control Panel
Language	English