17-7
TP27, TP37 Equipment Manual
Release 01/00
17.2.1 Installing the Control Panel Interface
A Touch Panel can accommodate either a control panel interface or a direct
key module (see section 17.1.1). Use the following procedure to install a con-
trol panel interface:
!
Caution
S Make sure that the Touch Panel is disconnected from the voltage supply.
S Always follow the ESD guidelines in the Appendix when working on open
devices.
1. Place the front panel of the Touch Panel on a workbench.
2. Release the two pop rivets ¶ and then the cover · indicated in figure 17-5
in an example of the TP37, from the rear panel of the Touch Panel.
·
¶¶
Figure 17-5 Removing the cover (example TP37)
Options
To Next Page
Loading...
