AMT Setup (MEBx)
4.1 Login and Configuration
BIOS Description
50 Operating Manual, 05/2016, A5E33664825-AB
"ME General Settings" submenu
Change ME Password Used to change the password
Local FW Update
Sets the user rights and the conditions under which ME firmware
updates can be transferred.
"AMT Configuration" submenu
Manageability Feature Selection
Enable and disable all AMT features.
Enable and disable the features SOL, IDE redirection, KVM.
User Consent User consent settings. Forces the following additional security
behavior: When a user attempts to establish a KVM connection
remotely, a six-figure number is displayed on the AMT PC. The
remote user must enter this number on the help desk PC before
the KVM connection can be opened.
Password Policy Password policy that specifies the conditions under which the
password can be changed from a remote location.
Network Setup Network settings, for example DHCP, IP address, host name,
Activate Network Access Activates the network interface. This menu entry only exists if
the network is not activated.
Unconfigure Network Access Deactivates the network interface and resets the network
settings to their default values.
Remote Setup And Configuration
Displays the current provisioning settings.
Power Control Specifies the power states S0, S3, S4 of the computer in which
Intel® Management Engine BIOS Extention (MEBX) User Guides
(https://communities.intel.com/docs/DOC-6112
)
To Next Page
Loading...
Need help?
General
