Commissioning a project
6.5 Backup and restore
KTP400 Basic, KTP600 Basic, KTP1000 Basic, TP1500 Basic
68 Operating Instructions, 08/2008, A5E01075587-01
6.5 Backup and restore
6.5.1 Overview
Backup and restore
You can back up and restore the following data found in the internal flash memory of the HMI
device with a PC:
● Project and HMI device image
● Password list
● Recipe data
Use one of the following tools for backup and restore:
● WinCC flexible
● ProSave
General information
NOTICE
Power failure
If a complete restore operation is interrupted due to power failure on the HMI device, the
operating system of the HMI device may be deleted. In this case, you have to reset the HMI
device to its factory settings.
Compatibility conflict
If a message is output on the HMI device warning of a compatibility conflict during the
restore operation, the operating system must be updated.
To Next Page
Loading...
Need help?
General
