5.7 General notes for SFP transceivers
WARNING
Use only approved SFP transceivers
If you use SFP transceivers that have not been approved by Siemens AG, there is no guarantee
that the device will function according to its specications.
If you use unapproved SFP transceivers, this can lead to the following problems:
• Damage to the device
• Loss of the approvals
• Violation of the EMC regulations
Use only approved pluggable transceivers.
Note
Plugging and pulling during operation
You can plug and pull pluggable transceivers with the device in operation.
Documentation for SFP transceivers
You will nd detailed information in the operating instructions of the pluggable transceivers, see
the chapter "Introduction (Page 5)" section "Additional documentation".
Installation
5.7 General notes for SFP transceivers
SCALANCE XM-400
52 Operating Instructions, 03/2021, C79000-G8976-C306-10
To Next Page
Loading...
Need help?
General