1-4
SIMATIC S5
C79000-G8576-C471-04
1.4 Notes on Operation
!
Caution
The mains plug of the eraser must be pulled before removing the eraser.
MOS security regulations must be observed when handling EPROMs
(cf DIN IEC 47(CO) 701).
When working in ambient temperatures of more than 35°C, you should
wait for 30 minutes after erasing an EPROM. This only applies to the
230 V model.
!
Warning
UV/C radiation is very strong and results in painful eye inflammation
and severe skin burns in a very short period of time.
Note
The device is set for a fixed supply voltage before leaving the factory.
The voltage selection switch must not be adjusted.
Device Model Drum Controller
230 V 230 V AC
120 V 115 V AC
Basic
Settings
Technical Description
To Next Page
Loading...
