Configuration of a faceplate
SIRIUS Motor Starter PCS 7 Library "V7.1+SP2"/ "V8 Migration V8.0+SP1"
30 Getting Started, 08/2013, A5E02897539020A/RS-AA/005
Updating faceplates
Note
If an older version of the PCS 7 SIRIUS Motor Starter Library was previously used in the
project, you can update the blocks.
1. Open the PCS 7 project in SIMATIC Manager.
2. Open WinCC by right-clicking the OS station. WinCC Explorer opens.
3. Navigate to "OS Project Editor" and open it.
4. Confirm with OK to update the faceplates in the WinCC project.
To Next Page
Loading...
