10. Confirm your entries with "OK."
11. In the "F-Configuration" tab of the Object Properties of the I-slave, select
"New."
12. In the next dialog, make the following entries for the send connection to the DP
master for our example:
- For "Mode: F-MS-S" (send over a fail-safe master to I-slave
communication)
- For "DP partner (receiver): address (LADDR): 2060"
- For "local (sender): address (LADDR): 268"
13. Confirm your entries with "OK."
This results in two configuration rows for this example:
Product Information for the S7 Distributed Safety, Configuring and Programming Manual
16 A5E00169432-02
To Next Page
Loading...
