Note
In the object properties of the relevant I-slave, entries are automatically made in
the "Configuration" tab based on the configuration in the "F-Configuration" tab.
These entries must not be modified. Otherwise, safety-related I-slave to I-slave
communication is not possible.
The assigned address areas on the DP master and I-slaves can be seen in the
"Configuration" tab.
Additional Information
You will find a description of the parameters in the context-sensitive online help of
the "F-Configuration" tab.
For information on programming safety-related I-slave to I-slave communication,
refer to Section 1.2.6.
For information on the address areas, process image partitions, and supported
interrupt OBs, refer to the Technical Specifications of the CPU you are using.
Product Information for the S7 Distributed Safety, Configuring and Programming Manual
22 A5E00169432-02
To Next Page
Loading...
