SIEMENS AG PRODAVE S7
Toolbox for Data Link PGs/PCs to SIMATIC S7
71
Calling the Demonstration Programs for Windows 95/98/NT/ME/2000:
Insert the appropriate data link cable PLC - PG/PC into the PG interface on
the PLC and into the MPI interface (and/or COM-Port when using the PC-
Adaptor- cable) of the PG/PC.
Configure the used PG/PC interface using the STEP7 tool
(S7EPATSX.EXE).
The access point of application ”S7ONLINE” must be linked to the used
module parameterisation.
In the event of a data link to S7-200 it is required to dial the relevant module
parameterisation with the suffix (PPI)
- Start Windows 95 again in to ensure the configuration is accepted.
- Start the demonstration program in the PRODAVE program group.
Select the load_tool menu and specify the parameters (address, slot
number, segment ID and rack number) of the destination system.
To Next Page
Loading...
