Siemens SIMATIC TP700 Comfort Outdoor - Connecting the Device

Mounting and connecting the HMI device
3.3 Connecting the device
TP700 Comfort Outdoor, TP1500 Comfort Outdoor
20 Compact Operating Instructions, 05/2016, A5E35956909-AC
Procedure
Note
Risk of guaranteed degree of protection not being met
If the mounting seal is damaged, the degree of protection is not guaranteed.
Replace the
device in this case.
Note
Installation of the HMI device
Always mount the HMI device according to the instructions in this manual.
Mounting clips for TP700 Comfort Outdoor:
Mounting clips for TP1500 Comfort Outdoor:
Proceed as follows:
1. Insert the HMI device into the mounting cutout from the front.
2. Insert the mounting clamp into the cutout provided on the HMI device.
3. Tighten the mounting clamp with the setscrew.
Note
Adhere to the permitted torque when tightening the setscrew of the mounting clamp:
0.5
Nm
4. Repeat steps 2 and 3 for all mounting clips.
5. Check the fit of the device in the mounting cutout.
3.3
Connecting the device
The specifications in "Comfort Panels" operating instructions apply.
The X3 interface "PROFINET (LAN) 10/100/1000 Mbit" is not featured on the
TP700 Comfort Outdoor and TP1500 Comfort Outdoor devices.