Siemens SIMATIC TP700 Comfort Outdoor - Climatic Ambient Conditions

Technical information
7.4 Climatic ambient conditions
TP700 Comfort Outdoor, TP1500 Comfort Outdoor
Compact Operating Instructions, 05/2016, A5E35956909-AC
27
7.4.2
Transport and short-term storage
The following information applies to a device that is transported in the original packaging and
weather-proof packaging, and stored from some time.
The device meets the requirements according to IEC 60721-3-2 Class 2K4 with the following
amendments and limitations:
Type of condition
Permitted range
Temperature
–30 ... 70 °C
Atmospheric pressure 1080 ... 660 hPa, corresponds to an elevation of -1000 to 3500 m
Relative humidity
10 ... 90 %
Pollutant concentration SO2: < 0.5 ppm; relative humidity < 60 %, no condensation
H
2
S: < 0.1 ppm; relative humidity < 60 %, no condensation
Note
If dewing has developed, wait approximately 4 hours until the HMI device has dried
completely before switching it on.
Do not expose the HMI device to direct radiation from a heater.
7.4.3
Operating Conditions
The following information applies to a device installed according to the specifications in these
compact operating instructions.
The HMI device is designed for stationary operation according to IEC 60721.
The device meets the requirements according to IEC 60721-3-3 Class 3K3 with the following
amendments and limitations:
Type of condition
Permitted range
Mounting position
Elevation
-1000 ... 2000 m
Elevation
3000 m *
Temperature,
Mounting in horizontal format
Vertical
-30 ... 60 °C
-30 ... 54 °C
Inclined, maximum inclination 35°
-30 ... 50 °C
-30 ... 45 °C
Temperature,
Mounting in vertical format
Vertical
-30 ... 50 °C
-30 ... 45 °C
Inclined, maximum inclination 35°
-30 ... 45 °C
-30 ... 40 °C
Atmospheric pressure,
operation elevation
1080 ... 795 hPa, corresponds to an elevation of -1000 to 2000 m
795 ... 701 hPa, corresponds to an elevation of 2000 ... 3000 m
Relative humidity
From 10 to 90%, without condensation
Pollutant concentration SO2: < 0.5 ppm; relative humidity < 60 %, no condensation
H
2
S: < 0.1 ppm; relative humidity < 60 %, no condensation
* Interpolation of the maximum temperature value is permitted in the range of 2000 ... 3000 m.
Note
The system components connected to the HMI device, the
power supply for example, must
also be suited to the respective operating conditions.