Overview
1.2 Software requirements
TP700 Comfort Outdoor, TP1500 Comfort Outdoor
8 Compact Operating Instructions, 05/2016, A5E35956909-AC
• External dimensions of the front and mounting cutout correspond to the
standard product
• Durable powder coating
• High UV resistance
• GFG (Glass-Film-Glass) touch screens, analog resistive
• Manual or automatic brightness control with brightness sensor
• High-resolution TFT display in widescreen format with 16 million colors
• Suitable for use in daylight
• Anti-reflective and bonded for glare-free reading
• Resistive single touch screen
• Suitable for operation with gloves, pen and fingers
• 2 PROFINET interfaces
• 1 PROFIBUS interface
• USB 2.0 ports:
– 2 x USB host interface (type A)
– 1 x USB device interface (type mini B)
Mechanical differences to the standard product
The Comfort Outdoor devices are deeper than the corresponding Comfort HMI
device.
Read the information in the following sections:
• Preparing the mounting cutout (Page 17)
• Dimension drawings (Page 29)
Slots for SD
memory cards
The protection mechanism of the SD memory card for the Comfort Outdoor
devices is mechanically differently than that of the corresponding Comfort HMI
device. The safety tab is not required with the Comfort Outdoor devices.
You require the software WinCC V13 SP1 (TIA Portal) Update 6 with the Hardware Support
Package "HSP0149 HMI TP700_1500 Comfort Outdoor" or later versions. You can find the
software under Technical Support on the Internet.
To Next Page
Loading...
