Siemens SIMATIC TP700 Comfort Outdoor - Page 22

Configuring the device
4.2 Changing the brightness settings
TP700 Comfort Outdoor, TP1500 Comfort Outdoor
22 Compact Operating Instructions, 05/2016, A5E35956909-AC
Select the "Manual" or "Auto" option.
– In the "Manual" mode, you can adjust the brightness to the desired value using the
slider.
Note
"Manual" mode
A change in the brightness value through the
configuration takes precedence over the
manual setting.
– in the "Auto" mode, you can set the minimum and maximum brightness for the
automatic brightness control of the HMI device under "Brightness Range".
NOTICE
"Auto" mode (factory state)
The brightness parameters are controlled by the light sensor in "Auto" mode. The
brightness can no longer be changed manually or through the configuration.
The "Screen saver" function is available as usual.
3. If you want to check the settings without closing the dialog, press the "Apply" button.
4. To discard the settings and close the dialog, press the "Cancel".
button. To save the settings and close the dialog, press the "OK" button.