EasyManuals Logo

Siemens SIMATIC WinCC flexible 2008 SP4 User Manual

Siemens SIMATIC WinCC flexible 2008 SP4
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Select the "Modicon Modbus" communication driver in the working area of the "Connections"
editor. Select the CPU type "Delta" on the "Parameters" tab.
HMI devices concerned:
1.
Smart 700 IE
2. Smart 1000 IE
Communication with LOGO! (0BA7)
WinCC flexible 2008 SP4 supports the LOGO! communication driver. The transfer takes place
via Ethernet.
HMI devices concerned:
1. Smart 700 IE
2. Smart 1000 IE
Extended address area for OMRON communication driver
The address area for the "DM" user data type has been extended. The address range is
between "0" and "32767".
HMI devices concerned:
1. Smart 700 IE
2. Smart 1000 IE
Address area for 3rd party controllers
Check the address area that is valid or usable for communication with 3rd party HMI Panel
and controllers.
Validity of documents in the online help
The documents specified in the WinCC flexible SP2 or SP3 online help are also valid for WinCC
flexible SP4 without limitation.
Readme
1.2 General Notes
Smart Panels
System Manual, 06/2012, 9

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC WinCC flexible 2008 SP4 and is the answer not in the manual?

Siemens SIMATIC WinCC flexible 2008 SP4 Specifications

General IconGeneral
BrandSiemens
ModelSIMATIC WinCC flexible 2008 SP4
CategoryControl Panel
LanguageEnglish

Related product manuals