Operation
Explosion-protected machines
130 56100000002002, 01/2016
Lubricating before recommissioning
Bearings can be damaged if they do not have sufficient grease.
• Re-grease the bearings if they have been out of service for more than one year.
The shaft must rotate so that the grease can be distributed in the bearings.
Observe the data on the lubricant plate.
Chapter Bearings (Page 140).
Note
Before removing any faults, please read the information in Chapter
Note
If you operate the motor with a converter, and an electrical fault occurs, then also
observe the
information in the converter operating instructions.
The tables below list general faults caused by mechanical and electrical influences.
To Next Page
Loading...
