See also
Service & support (Page 153)
10.2 Parts order
In addition to the exact part designation, please specify the machine type and the serial number
of the machine in all orders for spare parts and repair parts. Ensure that the part designation is
the same as that in the parts list, and make sure you also use the associated part number.
When spare and repair parts are ordered, the following details must be provided:
● Designation and part number
● Order number and serial number of the machine
The machine type and serial number can be found on the rating plate.
Rolling bearings
When ordering rolling bearings, in addition to the bearing identification code, the
supplementary specifying code is also necessary for the bearing version. Both of these codes
are stamped on the lubricant plate and specified in the motor documentation, or can also be
taken from the installed bearings.
Always replace the rolling bearings with the identical bearings.
10.3 Ordering spare parts via the Internet
You can use "Spares on Web" to determine the order numbers for motor
spare parts quickly and easily.
Spares on Web (https://www.sow.siemens.com/?lang=en).
10.4 Groups of parts
A distinction is made between the following groups of parts:
Spare parts
Spare parts are machine parts that can be ordered during the production time - and for a further
5 years after discontinuation of production. These parts should be replaced only by authorized
service or modification partners.
Repair parts
Repair parts are machine parts that can only be supplied during the active production of the
machine (until the product discontinuation). Repair parts are parts used for the repair or
Spare parts
10.4 Groups of parts
1MB5 SH 400/450
134 Operating Instructions, 05/2019, A5E45959221A
To Next Page
Loading...
