Connecting
5.2 Networking
SIMOTION C
Operating Instructions, 02/2012
131
5.2.6 Factory setting
After resetting the SIMOTION C to the factory setting (see chapter Setting SIMOTION C to
factory settings (Page 158)) or when the module is delivered, the following addresses are
s
et:
● Baud rate = 1.5 Mbit/s
● PROFIBUS address for the interfaces X8 = 2 and X9 = 2
● Ethernet interface:
IP address = 169.254.11.22
Subnet mask = 255.255.0.0
Router address = do not use a router
● PROFINET interface X11 (C240 PN)
IP address = no valid address
Subnet mask = no valid address
Router: Do not use a router
5.2.7 MPI subnet
An MPI subnet has the same basic configuration as a PROFIBUS subnet. The installation
rules, stated in the chapter Configuring a PROFIBUS subnet (Page 122), therefore apply.
To Next Page
Loading...
Need help?
General
