Siemens SIMODRIVE 611U User Manual

SIMATIC S7-300 Connecting the SIMODRIVE 611U to the Technology CPU
_
_____________
_
_____________
_
_____________
_
_____________
_
_____________
Definitions and warnings
1
Hardware Requirements
2
Software Requirements
3
Commissioning
4
Expert functions
5
SIMATIC
S7-300
Connecting the SIMODRIVE 611U
to the Technology CPU
Product Information
03/2008
A5E00272066-05

Siemens SIMODRIVE 611U Specifications

General

Brand	Siemens
Model	SIMODRIVE 611U
Category	Controller
Language	English

Summary

Definitions and warnings

Safety Guidelines

Qualified Personnel

Hardware Requirements

Converter

Lists SIMODRIVE 611U and POSMO SI closed-loop control module options.

Software Requirements

Software upgrade

Provides a step-by-step procedure for upgrading SIMODRIVE 611U firmware.

Commissioning

Table of Settings

Setting up a STEP 7 Project

Details creating a STEP 7 project, hardware configuration, and axis creation.

Create Axis

Describes creating an axis in S7T Config for the SIMODRIVE 611U.

Controller and Monitoring Settings

Referencing

Specifies homing modes and their procedures for axis positioning.

Load Program and Create DBs

Guides on loading the project into the CPU and generating technology data blocks.

Drive Configuration

Outlines using SimoCom U for drive configuration, including connection and initial setup.

Direct Parameter Entry

Expert functions