Siemens SIMODRIVE 611U - Setting up a STEP 7 Project

Commissioning
4.4 Setting up a STEP 7 project
Connecting the SIMODRIVE 611U to the Technology CPU
Product Information, 03/2008, A5E00272066-05
15
Note
The message frame types < 100 are standard message frames. These are standardized via
the PROFIdrive profile. The message frame types > 100 are device-specific message frame
types for the SIMODRIVE 611U.
4.4 Setting up a STEP 7 project
4.4.1 Performing the hardware configuration
Introduction
In this step, the technology CPU (in this example, the CPU 317T 2 DP), the bus system and
the connected devices, here the SIMODRIVE 611 universal, are configured in STEP 7 using
the hardware configuration program and S7T Config.
Procedure
● After starting the SIMATIC manager, you must first create a new project (e.g. with the
name
DSC_SIMODRIVE ):
Figure 4-1 Creating a project