Commissioning (software)
6.5 Additional information on configuring the SINAMICS Integrated
SIMOTION D4x5-2
210 Commissioning and Hardware Installation Manual, 02/2012
If you change the settings for the SINAMICS Integrated, you must also change the settings
on the CX32-2 modules accordingly. This is easily done by using the Align button to transfer
the settings for all the CX32-2 modules.
Figure 6-33 HW Config - settings
The times are modified by changing the value in the "Factor" field.
Additional references
Further information is available in the following references:
●
SINAMICS S120
Function Manual
●
SIMOTION SCOUT Basic Functions
Function Manual
To Next Page
Loading...
