Contents 06.2006
6SE7087-6KP50 Siemens AG
0-2 Operating Instructions SIMOVERT MASTERDRIVES
8.4
Parameter input with DriveMonitor ................................................................. 8-12
8.4.1 Installation and connection ............................................................................. 8-12
8.4.1.1 Installation.......................................................................................................8-12
8.4.1.2 Connection......................................................................................................8-12
8.4.2 Establishing the connection between DriveMonitor and the device ............... 8-13
8.4.2.1 Setting the USS interface ...............................................................................8-13
8.4.2.2 Starting the USS bus scan..............................................................................8-15
8.4.2.3 Creating a parameter set................................................................................8-16
8.4.3 Parameterization............................................................................................. 8-18
8.4.3.1 Structure of the parameter lists, parameterization with DriveMonitor ............8-18
8.4.3.2 General diagnostics........................................................................................8-23
8.5 Parameter reset to factory setting .................................................................. 8-24
8.6 Parameterizing by download .......................................................................... 8-25
8.7 Parameterizing with parameter modules........................................................ 8-26
8.8 Motor lists........................................................................................................ 8-39
8.9 Motor identification.......................................................................................... 8-49
8.10 Complete parameterization............................................................................. 8-49
9 MAINTENANCE ............................................................................................... 9-1
9.1 Replacing the fan.............................................................................................. 9-1
9.1.1 Replacing the fan in units up to 45 mm wide.................................................... 9-2
9.1.2 Replacing the fan in units up to 90 mm wide.................................................... 9-2
9.1.3 Replacing the fan in units 135 mm wide........................................................... 9-2
9.1.4 Replacing the fan in units up to 180 mm wide.................................................. 9-3
10 FORMING....................................................................................................... 10-1
11 TECHNICAL DATA........................................................................................ 11-1
12 FAULTS AND ALARMS ................................................................................ 12-1
12.1 Faults .............................................................................................................. 12-1
12.2 Alarms........................................................................................................... 12-13
12.3 Fatal errors (FF)............................................................................................ 12-36
13 ENVIRONMENTAL FRIENDLINESS.............................................................13-1
To Next Page
Loading...
